Where to start
-
thedudeman69
- Posts: 15
- Joined: Tue Nov 04, 2014 6:21 am
- Has thanked: 5 times
Where to start
Hello, I have a v1.6 NTSC xbox. I was wondering if someone could point me to a good, modern tutorial that I can use with all the files/software needed to load XBMC to my xbox? There are a ton of tutorials out there but most seem to not have all the files and I want to be sure it will work for my system. I also have a larger hard drive to install and could use some help with that as well. Thanks for your time!
-
spicemuseum
- Posts: 906
- Joined: Mon Jul 09, 2012 11:08 pm
- Has thanked: 94 times
- Been thanked: 75 times
Re: Where to start
Assuming you are starting with an unmodified XBOX, your first choice is whether to softmod or fit a modchip - and that largely depends on two factors: a) your skills with electronics and b) whether you want to achieve anything more complicated than simply getting unsigned code (such as XBMC) running on your box.thedudeman69 wrote:Hello, I have a v1.6 NTSC xbox. I was wondering if someone could point me to a good, modern tutorial that I can use with all the files/software needed to load XBMC to my xbox? There are a ton of tutorials out there but most seem to not have all the files and I want to be sure it will work for my system. I also have a larger hard drive to install and could use some help with that as well. Thanks for your time!
If you want to softmod start here (in the Guides and Tutorials section):
http://www.xbmc4xbox.org.uk/forum/viewt ... f=14&t=144