On all my modchips i solder d0 from the mainboard to ground (i use the ground from the screw which is close to LPC header), and on all the modchips i solder bt to ground on the chip board. This method allways worked for me. Hi What I remember form my installation is a wire from screw near LPC heade...

On some aladins you need to bridge a jumper to be able to flash them as the chip will suit two different flash chips and you need to set the jumper in the correct location to be able to flash them, some were factory set in the wrong position and did not suit the flash chips installed in them. Some ...

Hi Professor! Yes the old TSOP flash points are not bridged but I'm not trying to flash it. I'm trying to flash the modchip but it seams that the flash program can only see the TSOP not the modchip. Can the modchip not be properly installed but boot and work all fine? I know that it's working and I'...

Hi I have a Xbox 1.4v that recently I changed the TSOP to a Alladin just to make easier to flash the bios. But, I getting error "manufacturers id 09 device id 00 !! flash not writeable!!" using spider chip. Are my xbox still seeing the TSOP? Because everything I found this error was relate...

Issues which corruption or files failing to transfer after a certain amount of GB is a cluster issue, hens why I said to make sure they were formatted correctly. Download Chimp 261812 https://github.com/Rocky5/Chimp261812/archive/master.zip Inside the E partition folder there is a chimp folder stic...

Make sure the partition was formatted correctly, the version of XBP 1.3 kicking about may not actually be v1.3 I had to build the source to get v1.3 as the one labeled 1.3 was v1.2. But make sure the partition table and cluster size has been written correctly ( there will be no err labels on the ex...

Hi I wrote my problem in other thread but since this one is more active (have posts this year), I´m also writing here. Sorry if it´s againt forum rules (i can edit it if needed). I upgraded my Hdd to a SATA 1TB. Everything working but after a chunck of data transfered (280GB) I cannot write more on ...

Hi I´m new here and I´m bring this thread from the dead! :D I upgraded my Hdd to a SATA 1TB. Everything working but after a chunck of data transfered (280GB) I cannot write more on partition F. What I did: Evtools (Bios that I used M8 1.00.5838.01) partition 6 takes the rest of drive unchecked "...