XBMC4Xbox

Hi

I am new to this forum and hope you can help.I recently bought and old xbox original from a guy and he said it was modded but the chip didn't work when i opened the xbox there was a broken the wire.I cant see where it was joined to

Its a OzXchip with 256k bios and jumpers and i cant find a manual can you please help.

Hey

I sent you a PM with a new link but I'll post it here as well just in case.

"https://web.archive.org/web/20110815085 ... ev1.3).pdf"

I hope you get it up and running, good luck.

Probably the "D0" wire. It needs to be soldered to the point listed as "D0' on this picture. Determine which model Xbox you have and use the appropriate solder point.

Hint- put a small amount of solder on the tip of the solder iron and touch this onto the point. Do the same thing again but to the end of the wire. Place the wire on the point requiring the wire to go and touch it with the solder iron. Both the solder on the point and the wire should melt and join quickly.