XBMC4Xbox

I was asked if i could build a Xerc2 as they were sold out everywhere.
In the end i just did a redesign of the sickmods Xerc2 (XE).
My Layout has a few little differences to the Original Design but is almost the same. The biggest difference are the solder pads,
they have a bigger distance between them for an easier install.
They are completely assembled, tested and preprogrammed. It's as easy as installing and using them!

A kit consists of a Xerc2 and a necessary ir-Diode.
I would sell them for 15€ each! If youre interested in one (or more) drop me a PM!

Shipping to anywhere in the world would cost 3,50€. Inside Europe it's 2€.
I got a picture of an example install and the Xerc2 kit as i sell them.

I received my first board from N64 a few days ago and it is only when you have it in your hand that you appreciate what a lovely neat and small product this is.

I did say that I would post some pics when I install it but for now, I only had an hour or so spare so lashed it up quickly to test it out. What a great little mod for the money. Although the boards are very small, the solder pads have been kept a decent size so even beginners should not have too many problems installing one.

All my consoles have X3CPs and I was worried that the supplied IR eye was going to be too big to fit in the pre made space in the panel. It is a snug fit, but it does fit

Anyway - this is half the price of the X3IR, has far more functionality and is just as easy to install.

Thanks for your hard work on this buddy - really do appreciate your hard work.

Best regards, Mark

Hi Mark,
thank you for youre feedback!
Great to know you like my Layout of the Xerc2.