Page 1 of 1

openxenium help

Posted: Wed Jan 20, 2021 12:59 pm
by scroeffie
iam installed the modchip in my softmodded 1.6 xbox and it wont boot ,the chip turns on red led
but the xbox turns off on 3 times than nothing
i chekked continuity and all is good
dont know what to do ,before the chip the xbox worked fine
i used this guide ... 2358354378

reddit link to fotos ... nium_help/

Re: openxenium help

Posted: Thu Jan 21, 2021 5:00 am
by professor_jonny
you have likely missoldered something on the lpc board, or solder splater somewhere on th e motherboard.

if you remove d0 connection to ground it should boot the original bios if not you need to check your soldering and hope something is not broken now.

i dont like qsb's id go for a wire lpc rebuild.

Also I reecomend installing the current limiting resistor on a 1.6 as explained in the below link: ... ll_1.6.asp