iam installed the modchip in my softmodded 1.6 xbox and it wont boot ,the chip turns on red led
but the xbox turns off on 3 times than nothing
i chekked continuity and all is good
dont know what to do ,before the chip the xbox worked fine
i used this guide https://img1.wsimg.com/blobby/go/1edb4e ... 2358354378
reddit link to fotos https://www.reddit.com/r/originalxbox/c ... nium_help/
openxenium help
- professor_jonny
- Posts: 1296
- Joined: Thu Jul 05, 2012 5:41 am
- Location: New Zealand
- Has thanked: 66 times
- Been thanked: 196 times
Re: openxenium help
you have likely missoldered something on the lpc board, or solder splater somewhere on th e motherboard.
if you remove d0 connection to ground it should boot the original bios if not you need to check your soldering and hope something is not broken now.
i dont like qsb's id go for a wire lpc rebuild.
Also I reecomend installing the current limiting resistor on a 1.6 as explained in the below link:
https://web.archive.org/web/20050306185 ... ll_1.6.asp
if you remove d0 connection to ground it should boot the original bios if not you need to check your soldering and hope something is not broken now.
i dont like qsb's id go for a wire lpc rebuild.
Also I reecomend installing the current limiting resistor on a 1.6 as explained in the below link:
https://web.archive.org/web/20050306185 ... ll_1.6.asp