openxenium help

Discussion about Modding the XBOX, including hardware and software hacks.
Post Reply
scroeffie
Posts: 322
Joined: Tue Jan 07, 2014 1:08 pm
Has thanked: 41 times
Been thanked: 16 times

openxenium help

Post by scroeffie »

iam installed the modchip in my softmodded 1.6 xbox and it wont boot ,the chip turns on red led
but the xbox turns off on 3 times than nothing
i chekked continuity and all is good
dont know what to do ,before the chip the xbox worked fine
i used this guide https://img1.wsimg.com/blobby/go/1edb4e ... 2358354378


reddit link to fotos https://www.reddit.com/r/originalxbox/c ... nium_help/
User avatar
professor_jonny
Posts: 1296
Joined: Thu Jul 05, 2012 5:41 am
Location: New Zealand
Has thanked: 66 times
Been thanked: 196 times

Re: openxenium help

Post by professor_jonny »

you have likely missoldered something on the lpc board, or solder splater somewhere on th e motherboard.

if you remove d0 connection to ground it should boot the original bios if not you need to check your soldering and hope something is not broken now.

i dont like qsb's id go for a wire lpc rebuild.

Also I reecomend installing the current limiting resistor on a 1.6 as explained in the below link:
https://web.archive.org/web/20050306185 ... ll_1.6.asp
Post Reply