https://www.youtube.com/watch?v=guL2BQLdfFg
So i received my hard modded Xbox today, everything worked fine until i disassembled it.
I broke a cable from the motherboard, now my Xbox wont start up and i need help
Thank you
Xecuter 2 cable help
- xman
- Posts: 1289
- Joined: Wed Jul 04, 2012 2:30 pm
- Location: Sydney, Australia
- Has thanked: 55 times
- Been thanked: 168 times
Re: Xecuter 2 cable help
Looks like your D0 wire has come off. Look in the modchip section at any modchip data and it will show where the wire needs to go. All modchips require it so they are all the same. Use the D0 point on the underside of the board, it is much easier to join to than the one on the top of the board.
Re: Xecuter 2 cable help
As Xman says - your D0 wire has become disconnected.
This might help:
http://www.xbox-scene.com/articles/endisable.php
This might help:
http://www.xbox-scene.com/articles/endisable.php
- professor_jonny
- Posts: 1296
- Joined: Thu Jul 05, 2012 5:41 am
- Location: New Zealand
- Has thanked: 66 times
- Been thanked: 196 times
Re: Xecuter 2 cable help
By the way it is an akira 2 modchip also called an ak2
It has an xecuter 2 bios on it.
It has an xecuter 2 bios on it.
Re: Xecuter 2 cable help
Yea, that's an Akira 2 modchip..
here's the install dirrections: http://dwl.xbox-scene.com/~xbox/xbox-sc ... ams_15.htm
here's the install dirrections: http://dwl.xbox-scene.com/~xbox/xbox-sc ... ams_15.htm